![ultimaker cura ender 3 settings ultimaker cura ender 3 settings](https://tweakers.net/ext/i/2001955605.png)
![ultimaker cura ender 3 settings ultimaker cura ender 3 settings](https://i.stack.imgur.com/yYDwP.jpg)
Generally you will want your prints to have at least 1.2 mm total Wall Thickness in order to be sturdy when handled. For a 0.4mm nozzle that means the total Wall Thickness would usually be: 0.8mm, 1.2mm, 1.6mm, or 2.0mm.Your total Wall Thickness should be a multiple of your nozzle size.Line Width should usually be the same as your nozzle size (0.4mm nozzle size is assumed here.).Each individual Wall will be the same thickness as your Line Width.You could increase slightly to 101% to help with bed adhesion, but this shouldn’t be necessary with a well leveled bed.
Ultimaker cura ender 3 settings install#
If you install a different sized nozzle, be sure this is updated to match! Some other common nozzle sizes are 0.2, 0.6, 0.8, etc. Leave it set to default, the same as the width of your nozzle. As a general rule add 0.08 to your layer layer height, or use double your layer height if using fine detail like 0.12 layer height. Thicker initial layer height helps bed adhesion. If you want even thicker layer heights, step up to a 0.6 or 0.8mm nozzle first. Stick to 0.12 (fine detail) or 0.2 (standard detail) usually. If you see a mistake or want to make a suggestion please leave a comment below!.Disclaimer: The author takes no responsibility for any damage that might occur from use or misuse of information presented here.
![ultimaker cura ender 3 settings ultimaker cura ender 3 settings](https://cdn.shopify.com/s/files/1/0151/1735/files/Cura-optimized-profiles_1024x1024.png)